![]() Avioms RS-232/422 port uses a male DB9 connector and therefore. CAN Sync Start Multiple with NI-DAQmx. DB9 cables are available with male-to-male, female-to-female, and male-to-female connectors.Channel API Additional Programming Topics.Low-Speed/Fault-Tolerant CAN Pinout Cable.Verify Installation of CAN and LIN Hardware.Measurement & Automation Explorer (MAX).For more information refer to the ncSetAttribute function within the Frame API. On NI USB-LIN products, master termination is software selectable and can be enabled with the Termination attribute. The master node requires a 1 KΩ resistor and serial diode between the LIN bus and VBat. An RS-232 serial port was once a standard feature of a personal computer, used for connections to modems, printers, mice, data storage, uninterruptible power supplies, and other peripheral devices. This termination is usually integrated into the transceiver package. Submit New This RS232C DE-9 (usually miscalled DB-9) port is available in some PCs and many other devices. Slave nodes are typically pulled up from the LIN bus to VBat with a 30 KΩ resistance and a serial diode. ![]() LIN cables require no termination, as nodes are terminated at the transceiver. The picture shows standard connection between 8051 and DB-9 via MAX232. The maximum number of devices on a LIN bus is 16, per the LIN specification. The maximum allowable cable length is 40 meters, per the LIN specification. For detailed formulas for calculating this value, refer to the Line Characteristics section of the LIN specification.īelden cable (3084A) and other unterminated CAN/Serial quality cables meet these requirements, and should be suitable for most applications. LIN cables should meet the physical medium requirement of a bus RC time constant of 5 microseconds. This section describes cabling requirements for LIN. ![]() All USB-LIN interfaces require bus power of 8-18 VDC.Ĭabling Requirements for LIN Specifications (LIN) Supplies bus power to the LIN physical layer, as required by the LIN spec. Signal line that carries the data on the LIN. Connecting the optional LIN shield may improve signal integrity in a noisy environment. The following figure shows the 9-pin D-Sub connector pinout. USB-8476 and USB-8476s hardware has a 9-pin male D-Sub (DB9) connector for connection to the LIN bus. This section describes the USB-LIN hardware. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |